Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке: https://scidar.kg.ac.rs/handle/123456789/11056
Назив: Determination of tribological properties of aluminum cylinder by application of Taguchi method and ANN-based model
Аутори: Milojević, Saša
Stojanovic, Blaza
Часопис: Journal of the Brazilian Society of Mechanical Sciences and Engineering
Датум издавања: 1-дец-2018
Сажетак: © 2018, The Brazilian Society of Mechanical Sciences and Engineering. Energy losses due to friction and wear in reciprocating machines could be potentially reduced by applying new surface, materials and lubrication technologies for friction reduction and wear protection. In this paper, the tribological properties of ferrous-based reinforcements are tested and compared with aluminum alloy (EN AlSi10Mg) as a base material for cylinder of air compressor. The ball-on-plate CSM tribometer is used to carry out these tests under dry sliding conditions and constant sliding distance, for three different values of sliding speed and normal load. The wear factor is analyzed by using Taguchi method as well as artificial neural network-based model, with the aim of finding the optimal parameters. The result of signal-to-noise ratio and analysis of variance shows that the best tribological properties were achieved with reinforcements. Material has the greatest impact on the wear factor (35.54%), followed by load (22.16%) and sliding speed (6.01%). A good superposition was reached of the results obtained by the Taguchi method with the results of the artificial neural network-based model. According to the analysis of surface micrographs, it can close that the bonding material is the most dominant mechanism of wear for both tested materials.
URI: https://scidar.kg.ac.rs/handle/123456789/11056
Тип: article
DOI: 10.1007/s40430-018-1495-8
ISSN: 16785878
SCOPUS: 85057053262
Налази се у колекцијама:Faculty of Engineering, Kragujevac

Број прегледа

54

Број преузимања

3

Датотеке у овој ставци:
Датотека Опис ВеличинаФормат 
10.1007-s40430-018-1495-8.pdf2.05 MBAdobe PDFСличица
Погледајте


Ставке на SCIDAR-у су заштићене ауторским правима, са свим правима задржаним, осим ако није другачије назначено.