Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке: https://scidar.kg.ac.rs/handle/123456789/11608
Назив: Experimental-numerical analysis of contact conditions influence on the ironing strip drawing process
Аутори: Djordjevic, Milan
Mandic, Vesna
Aleksandrovic, Srbislav
Lazic, Vukic
Arsić, Dušan
Nikolic, Ruzica
Gulišija Z.
Датум издавања: 2017
Сажетак: © 2017, Emerald Publishing Limited. Purpose: The purpose of this paper is comparison of experimental values of the drawing forces to numerical values in different contact conditions, taking into account the appearance of galling which occurs due to of difficult drawing process conditions. Design/methodology/approach: The following two research approaches are used in this paper – the physical modeling, realized by the laboratory experiment, and the numerical simulation of the ironing drawing process. By analyzing the obtained results, the technique of physical modeling, with help of the laboratory equipment and numerical simulation by application of the finite element method, can be successfully used in studying the thin sheet ironing – strip drawing process. Findings: It is significant to compare values of the deformation forces obtained by physical experiment to values obtained by the numerical simulation. In that way, it is possible to compare applied contact conditions (four lubricants in that case) and estimate matching of experimentally and numerically obtained results of the deformation forces. Presented results point out very good technological characteristics of ecologically friendly lubricant (single-bath) and grease based on MoS2. Significant decrease of the deformation force was achieved by its application, as well as maintaining of the lubricant’s layer during the forming process and almost complete elimination of galling on the contact. Practical implications: Numerical analysis of stresses in the working piece wall, during the thin sheet strip drawing, requires precise values of the friction coefficient. It is an important indicator because one can define the contact conditions as the input data for the numerical simulation, based on its values for each type of lubricants and each value of the compressive lateral force. Originality/value: The environmentally friendly lubricant tested exhibits a more favorable distribution of the drawing force during the process, mainly in experimental case. Grease based on MoS2 has good lubricating properties but that lubricant is conventional and environmentally unacceptable. Ecologically friendly lubricant can be successfully used in real ironing strip drawing process especially for high values of holding force achieving an increased tool life.
URI: https://scidar.kg.ac.rs/handle/123456789/11608
Тип: article
DOI: 10.1108/ILT-05-2016-0113
ISSN: 0036-8792
SCOPUS: 2-s2.0-85046546057
Налази се у колекцијама:Faculty of Engineering, Kragujevac

Број прегледа

132

Број преузимања

6

Датотеке у овој ставци:
Датотека Опис ВеличинаФормат 
PaperMissing.pdf
  Ограничен приступ
29.86 kBAdobe PDFСличица
Погледајте


Ставке на SCIDAR-у су заштићене ауторским правима, са свим правима задржаним, осим ако није другачије назначено.