Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке: https://scidar.kg.ac.rs/handle/123456789/12390
Назив: Model testing of fixture-workpiece interface compliance in dynamic conditions
Аутори: Tadic, Branko
Vukelic, Djordje
Miljanic D.
Bogdanović B.
Macuzic, Ivan
Budak I.
Todorovic, Petar
Датум издавања: 2014
Сажетак: This paper is focused on the problem of compliance of interface between clamping/locating fixture elements and workpiece, under dynamic loads during machining. In contrast to previous investigations, the authors have developed a special device dedicated to testing of physical models which represent clamping/locating elements and workpiece. This device allows optimization of a large number of input parameters which are critical to interface compliance. It was used in experimental investigations to establish the impact that the radius of the spherical tip of a clamping/locating element has on the interface compliance and load capacity. The results of experimental investigation show that, under certain conditions, the clamping/locating elements with larger-radius spherical tips provide significantly lower interface compliance. Future investigations should be aimed at finding optimum macro- and micro-geometries of contact interface, as well as the selection of materials for clamping/locating elements. © 2013 The Society of Manufacturing Engineers.
URI: https://scidar.kg.ac.rs/handle/123456789/12390
Тип: article
DOI: 10.1016/j.jmsy.2013.05.004
ISSN: 0278-6125
SCOPUS: 2-s2.0-84895060312
Налази се у колекцијама:Faculty of Engineering, Kragujevac

Број прегледа

140

Број преузимања

6

Датотеке у овој ставци:
Датотека Опис ВеличинаФормат 
PaperMissing.pdf
  Ограничен приступ
29.86 kBAdobe PDFСличица
Погледајте


Ставке на SCIDAR-у су заштићене ауторским правима, са свим правима задржаним, осим ако није другачије назначено.