Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке: https://scidar.kg.ac.rs/handle/123456789/20457
Назив: Electrical resistance spot brazing of two different alloys
Аутори: Lazic, Vukic
Arsić, Dušan
Milan, Djordjevic
Nikolic, Ruzica
Hadzima, Branislav
Датум издавања: 2016
Сажетак: The general problems related to electrical resistance brazing of various metals were considered in this paper. In brazing different electrodes and technological parameters are used. For experimental purposes, electrodes were made of highly alloyed tungsten steel and of copper with graphite and tungsten inserts, so the symmetrical temperature field was obtained. Success of brazing was determined by testing the mechanical properties, micro hardness and microstructure of the brazed joint. Hardness measurement results suggested the strain hardening of the steel thin sheets, what imposed necessity of recrystallization annealing. It was necessary to apply both the flux and the silver solder for joining, since copper and iron are poorly mutually soluble. When the metallurgy problems were solved and the optimal brazing parameters selected, the optimal mechanical properties were achieved, which were experimentally confirmed.
URI: https://scidar.kg.ac.rs/handle/123456789/20457
Тип: conferenceObject
Налази се у колекцијама:Faculty of Engineering, Kragujevac

Број прегледа

341

Број преузимања

20

Датотеке у овој ставци:
Датотека Опис ВеличинаФормат 
b19249-20 - V. Lazic et. al.pdf1.91 MBAdobe PDFСличица
Погледајте


Ова ставка је заштићена лиценцом Креативне заједнице Creative Commons