Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке: https://scidar.kg.ac.rs/handle/123456789/8531
Назив: Reducing the melting and sublimation of the galvanized sheets zinc layer during the laser beam cutting
Аутори: Mesko J.
Nigrovic R.
Nikolic, Ruzica
Датум издавања: 2018
Сажетак: © 2018 Institute of Physics Publishing. All rights reserved. The presented research is dealing with principles and technology of the laser cutting. The properties of the CO2 laser beam, input parameters of the laser cutting, assist gasses, interaction with the cut material and the cutting process stability are described. Influence of the heat from the laser beam on degradation of the zinc surface layer, which serves as the anti-corrosive protection of the lower carbon steel, is considered in this paper. In the experimental part of this research, the two most important laser cutting parameters were experimentally changed, namely the type of the assist gas - O2 and N2 and the cutting speed.
URI: https://scidar.kg.ac.rs/handle/123456789/8531
Тип: conferenceObject
DOI: 10.1088/1757-899X/393/1/012096
ISSN: 1757-8981
SCOPUS: 2-s2.0-85051854827
Налази се у колекцијама:Faculty of Engineering, Kragujevac

Број прегледа

148

Број преузимања

7

Датотеке у овој ставци:
Датотека Опис ВеличинаФормат 
10.1088-1757-899X-393-1-012096.pdf635.18 kBAdobe PDFСличица
Погледајте


Ова ставка је заштићена лиценцом Креативне заједнице Creative Commons