Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке: https://scidar.kg.ac.rs/handle/123456789/10733
Назив: Modelling of Cutting Forces in Hard Steel Turning
Аутори: Pavel K.
Mirfad T.
Nedic, Bogdan
Borislav S.
Dušan Golubovic
Dušan J.
Датум издавања: 2020
Сажетак: © Springer Nature Switzerland AG 2020. The aim of this study is to investigate the effect of machining parameters on cutting resistance during hard steel turning. This paper describes a novel approach in cutting resistance modeling using a design experiment. The output of the processing should take into account the cutting resistance they measured when testing the range of speeds, displacements, and depth of bursting. Mathematical models have been obtained that have been shown to have high confidence that they can approximate the measurement results. The connection between cutting forces in terms of changing the parameters of the cutting mode, as well as the undesirable occurrence and wear of the tool, which is certainly present in the process of removing hard-working material, is given.
URI: https://scidar.kg.ac.rs/handle/123456789/10733
Тип: conferenceObject
DOI: 10.1007/978-3-030-46817-0_24
ISSN: 2367-3370
SCOPUS: 2-s2.0-85085158783
Налази се у колекцијама:Faculty of Engineering, Kragujevac

Број прегледа

484

Број преузимања

9

Датотеке у овој ставци:
Датотека Опис ВеличинаФормат 
PaperMissing.pdf
  Ограничен приступ
29.86 kBAdobe PDFСличица
Погледајте


Ставке на SCIDAR-у су заштићене ауторским правима, са свим правима задржаним, осим ако није другачије назначено.