Please use this identifier to cite or link to this item:
https://scidar.kg.ac.rs/handle/123456789/10514
Full metadata record
DC Field | Value | Language |
---|---|---|
dc.rights.license | openAccess | - |
dc.contributor.author | Ribic-Zelenovic, Lenka | - |
dc.contributor.author | Spasojević M. | - |
dc.contributor.author | Ćirović N. | - |
dc.contributor.author | Spasojević P. | - |
dc.contributor.author | Maricic, Aleksa | - |
dc.date.accessioned | 2021-04-20T15:57:20Z | - |
dc.date.available | 2021-04-20T15:57:20Z | - |
dc.date.issued | 2012 | - |
dc.identifier.issn | 0350-820X | - |
dc.identifier.uri | https://scidar.kg.ac.rs/handle/123456789/10514 | - |
dc.description.abstract | A nanostructured Ni-11.3Fe-1.4W alloy deposit was obtained from an ammonium citrate bath at a current density of 600 mAcm -2. XRD analysis shows that the deposit contains an amorphous matrix having embedded nanocrystals of the FCC phase of the solid solution of Fe and W in Ni with the average crystal grain size of 8.8 nm. The deposit has a high internal microstrain value and a high minimum density of chaotically distributed dislocations. The effect of milling and annealing of the Ni-11.3Fe-1.4W alloy on electrical and magnetic properties was studied. Structural changes in the alloy take place during both annealing and milling. Upon deposition, the alloy was heated to 420 °C. Heating resulted in structural relaxation which induced a decrease in electrical resistivity and an increase in magnetic permeability of the alloy. Further heating of the alloy at temperatures higher than 420 °C led to crystallization which caused a reduction in both electrical resistivity and magnetic permeability. The milling of the alloy for up to 12 hours caused a certain degree of structural relaxation and crystallization of the alloy. The increase in crystal grain size up to 11 nm and the partial structural relaxation induced a decrease in electrical resistivity and an increase in magnetic permeability of the alloy. Heating the powders obtained by milling at 420 °C led to complete structural relaxation, reduced electrical resistivity, and increased magnetic permeability. During heating of the powders obtained by milling at temperatures above 420 °C, crystallization and a significant increase in crystal grain size occurred, leading to a reduction in both electrical resistivity and magnetic permeability. The best magnetic properties were exhibited by the alloys milled for 12 hours and annealed thereafter at 420 °C. In these alloys, crystal grains were found to have an optimum size, and complete relaxation took place, resulting in a maximum increase in magnetic permeability. | - |
dc.rights | info:eu-repo/semantics/openAccess | - |
dc.rights.uri | https://creativecommons.org/licenses/by-nc-nd/4.0/ | - |
dc.source | Science of Sintering | - |
dc.title | Effect of milling and annealing on microstructural, electrical and magnetic properties of electrodeposited Ni-11.3fe-1.4W alloy | - |
dc.type | article | - |
dc.identifier.doi | 10.2298/SOS1202197S | - |
dc.identifier.scopus | 2-s2.0-84866384876 | - |
Appears in Collections: | Faculty of Agronomy, Čačak |
Files in This Item:
File | Description | Size | Format | |
---|---|---|---|---|
0350-820X1202197S.pdf | 393.68 kB | Adobe PDF | ![]() View/Open |
This item is licensed under a Creative Commons License