Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке: https://scidar.kg.ac.rs/handle/123456789/9317
Пун извештај метаподатака
Поље DC-а ВредностЈезик
dc.rights.licenseopenAccess-
dc.contributor.authorTadić B.-
dc.contributor.authorTodorovic, Petar-
dc.contributor.authorNovkinic B.-
dc.contributor.authorBuchmeister, Borut-
dc.contributor.authorRadenkovic M.-
dc.contributor.authorBudak I.-
dc.contributor.authorVukelic, Djordje-
dc.date.accessioned2020-09-19T18:00:24Z-
dc.date.available2020-09-19T18:00:24Z-
dc.date.issued2015-
dc.identifier.issn1726-4529-
dc.identifier.urihttps://scidar.kg.ac.rs/handle/123456789/9317-
dc.description.abstract© 2015, Vienna University of Technology. All Right Reserved. Proposed in this paper is a novel approach to fixture layout design. The contact interface between workpiece and fixture is reduced to a single workpiece surface. This allows reliable machining of the remaining five workpiece surfaces in a single setup. Workpiece clamping is performed by inserting special elements into prepared auxiliary openings on the workpiece. Clamping is thus reduced to indenting of sharp clamping element tips into the workpiece surface. Shallow indenting is performed on surfaces which have no practical function. Special device was designed to allow experimental investigation. Experimental results point towards the efficiency of the proposed approach. Workpiece displacements were small during machining and allowed the required machining accuracy. Furthermore, the results obtained during machining indicate high surface quality.-
dc.rightsinfo:eu-repo/semantics/openAccess-
dc.rights.urihttps://creativecommons.org/licenses/by-nc-nd/4.0/-
dc.sourceInternational Journal of Simulation Modelling-
dc.titleFixture layout design based on a single-surface clamping with local deformation-
dc.typearticle-
dc.identifier.doi10.2507/IJSIMM14(3)1.280-
dc.identifier.scopus2-s2.0-84947803183-
Налази се у колекцијама:Faculty of Engineering, Kragujevac

Број прегледа

1074

Број преузимања

175

Датотеке у овој ставци:
Датотека Опис ВеличинаФормат 
10.2507-IJSIMM14(3)1.280.pdf610.01 kBAdobe PDFСличица
Погледајте


Ова ставка је заштићена лиценцом Креативне заједнице Creative Commons