Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке: https://scidar.kg.ac.rs/handle/123456789/9317
Назив: Fixture layout design based on a single-surface clamping with local deformation
Аутори: Tadić B.
Todorovic, Petar
Novkinic B.
Buchmeister, Borut
Radenkovic M.
Budak I.
Vukelic, Djordje
Часопис: International Journal of Simulation Modelling
Датум издавања: 1-јан-2015
Сажетак: © 2015, Vienna University of Technology. All Right Reserved. Proposed in this paper is a novel approach to fixture layout design. The contact interface between workpiece and fixture is reduced to a single workpiece surface. This allows reliable machining of the remaining five workpiece surfaces in a single setup. Workpiece clamping is performed by inserting special elements into prepared auxiliary openings on the workpiece. Clamping is thus reduced to indenting of sharp clamping element tips into the workpiece surface. Shallow indenting is performed on surfaces which have no practical function. Special device was designed to allow experimental investigation. Experimental results point towards the efficiency of the proposed approach. Workpiece displacements were small during machining and allowed the required machining accuracy. Furthermore, the results obtained during machining indicate high surface quality.
URI: https://scidar.kg.ac.rs/handle/123456789/9317
Тип: journal article
DOI: 10.2507/IJSIMM14(3)1.280
ISSN: 17264529
SCOPUS: 84947803183
Налази се у колекцијама:Faculty of Engineering, Kragujevac

Број прегледа

70

Број преузимања

20

Датотеке у овој ставци:
Датотека Опис ВеличинаФормат 
10.2507-IJSIMM14(3)1.280.pdf610.01 kBAdobe PDFСличица
Погледајте


Ставке на SCIDAR-у су заштићене ауторским правима, са свим правима задржаним, осим ако није другачије назначено.